If the old controller has only one common wire, you can connect it to either one of the “C” slots and the other “C” slot will sit empty.lf yOu do not have a master valve or a pump, you can leave this “M” slot unconnected. In some controllers, it is named as “PMV” or “P/MV”. The slot named “M” is for the master valve or the pump.Use the picture of the wires on your old controller to help you remember.Reconnect the wires to the slots on the base Use the air bubble to position horizontally. Install the Sprite base to the wall using the two screws included.Sprite is incompatible with 5 GHz Wi-Fi networks.Īlso, please make sure the SSID (name of your home Wi-Fi) and the password do not contain special characters like spaces or quotation marks. Sprite only supports the newer standards, namely Wireless-N, Wireless-G and Wireless-AC. We recommend a signal of at least 2 bars on your phone note: Sprite is unable to connect to Wireless-B(11Mbps) routers. Check the strength of the WiFi signal at the location where your Sprite will be installed.When you are wiring Sprite, this photo can be the reference. Take a photo of the wiring in your old controller.Unplug the power of your current controller.Please contact us or irrigation professionals for additional support.
If the reading is less than 10 Ohms then you might have a shorted circuit in the solenoid and if it is larger than 80 Ohms you might have an open circuit. You just need to use a multimeter to measure the resistance between the common wire and each zone. Note: If you are not sure about the condition of your sprinkler system, you might want to check whether there are shorted zones or open zones. If it does not work, please make sure it is repaired before installing the Sprite. Test the functionality of your irrigation system with your current controller first.
#Led sprite master sword manuals
15.1 Related Manuals / Resources NETRO SPRITE Smart Watering Controller Contents Preparation
0 kommentar(er)
